Table of Contents
Advertisement
5.4
Mounting
Flush-mounted installation box
The devices with integrated bus coupler have been prepared for installing in special flush-
mounted boxes in connection with the corresponding support ring. The device insert has
already been attached to the support ring (magnetic holder). To mount it, the device must be
pulled off the support ring.
The device is installed in flush-mounted installation box 6226 U. For flush-mounted or hollow-
wall installation.
X
Fig. 5:
Mounting height
NOTE
For the installation of the flush-mounted installation box see also the mounting
instructions on the template.
Fig. 6:
Installation of the flush-mounted installation box according to template
NOTE
Note that the connecting cables for the power supply, the free@home bus and
the external RTC temperature sensor (option) must be fed through the
previously pierced cable feed-through on the left side. Also a cable duct (Ø 20
mm) can be used as an option.
Product manual 2CKA001473B9085
Connection and installation
The mounting height X is approx. 1.5 m.
│15
Advertisement
Table of Contents
