Figure 111. Replacing the RDX drive filler
b) Push in the clips (B) to snap the filler into the chassis.
10. Replace the air baffle. For instructions, see Replacing the air baffle (www.ibm.com/support/
knowledgecenter/POWER9/p9haj/p9haj_914_924_airbafflereplace.htm).
Preparing the 9009-41G or 9009-42G system for operation after removing and replacing
the NVMe drive backplane
To prepare the system for operation after removing and replacing the NVMe drive backplane, complete
the steps in this procedure.
Procedure
1. Replace the service access cover.
For a rack-mounted system, complete the following steps. Refer to Figure 112 on page 124.
a. Slide the cover (A) onto the system unit.
b. Close the release latch (B) by pushing it in the direction shown.
Drive backplanes for the 9009-41A, 9009-41G, 9009-42A, 9009-42G, or 9223-42H 123