Storage - Graco SaniSpray HP 20 Operation - Repair - Parts

Cleanup and Storage
b. Reverse the Spray Tip to UNCLOG
position, pull the Trigger for 30
seconds until sprayer is clean.
Release the Trigger.
NOTICE
Do not run sprayer without fluid. Running
sprayer dry will cause damage to the
pump.
13. Turn Prime Knob downward to PRIME
position.
14. Disconnect power (unplug Power Cord).
15. Remove cup assembly from sprayer.
Separate Cup Lid from Cup Support and
pour unused water into waste bucket.
16. Dispose of the fluid in the waste bucket
according to the instructions on the
disinfectant container label and
applicable regulations.
17. Remove Spray Tip, Spray Tip Guard,
and Pump Filter from sprayer. Clean with
warm water. A soft brush can be used if
needed.
22
18. Use a soft cloth to clean the Cup
Support, Cup Lid and sprayer.
19. Wipe disinfectant off the outside of the
sprayer using a soft cloth moistened with
water.

Storage

•
Do not allow water to freeze in sprayer.
•
Do not store sprayer under pressure.
Confirm the Prime Knob is downward in
PRIME position.
•
Store sprayer in an upright position only.
•
Store sprayer indoors in a cool, dry
place.
•
Store Spray Tip, Spray Tip Guard, and
Pump Filter with sprayer so they are
available for the next job.
ti23372a
3A7646F