Mounting The Power Center - Pentair EASYTOUCH PL4 Installation Manual

6
Mounting the EasyTouch
Center
Mount the EasyTouch PL4/PSL4 Control System Power Center enclosure on a flat vertical surface,
such as a wall or post at eye level, at least 5 ft. (1.5 m), (Canada 3 m (9.75 ft)) from the pool, spa or
hot tub.
To mount the Power Center:
1. Position the enclosure against a vertical flat surface. If wall anchors are being used,
support the enclosure in position (horizontally level and square) against the surface and
mark the bracket hole pattern on the wall.
2. Secure the enclosure with three (3) screws in the top and lower mounting bracket holes. If
using wall anchors, drill and set the anchors and secure the enclosure with screws.
EASYTOUCH PL4/PSL4 Control System Installation Guide
®
®
Top mounting bracket screw holes
Lower mounting bracket screw holes
EasyTouch PL4/PSL4 Control System Power Center (front view)
(Front door and high voltage panel removed)
PL4/PSL4 Control System Power