R
EMOVING THE
F
RAME
Step 15
•
Using a flat screw driver, remove the
eight round caps (four on each side) of
the guillotine frame.
•
Using either a flat screw driver or bare
hands, remove the decorative cover at
the top of the guillotine frame. It is
pressure fitted, pull down and out.
10
G
UILLOTINE
Step 16
•
Using a small ratchet with a
(2" min.) magnetic socket, remove the
bottom nut on both sides. They are
behind the bottom holes you have
uncovered by removing the round caps.
•
Push the guillotine frame up by a
couple of inches and pull down on the
bottom piece of the frame. Be careful
not to damage the stainless steel
gasket under this piece. It is very
fragile.
You can stop here if you only want to
change the stainless steel gasket at
the bottom of the guillotine frame.
7
/
" long
16