Removing Icsa From Stroller; Removing Restraint Belt From Stroller - Britax BOB Gear Duallie CS1011 Instructions Manual

7. Lift Red Frame Release Handle
Using a short, quick tug, lift red frame
release handle up. Keep tires on
ground as stroller collapses toward
front wheel (see stroller owner's
manual if necessary).
NOTE: We do not recommend
leaving stroller folded with ICSA
installed for long periods of time as
it may leave an imprint in the stroller
seat. For long term folded storage,
remove ICSA.

REMOVING ICSA FROM STROLLER

Remove Infant Car Seat Adapter
and Restraint Belt when not in use.
Do not place children directly in the
stroller seat with the Infant Car Seat
Adapter installed. Remove Infant
Car Seat Adapter from stroller prior
to placing a child directly into the
stroller seat.
Failure to follow these warnings
may result in serious injury or
death.
1. Prepare Stroller
Set parking brake, rotate canopy
towards handlebar (see stroller
owner's manual if necessary).
NOTE: For illustrative purposes,
Chicco compatable ICSA shown.
Other ICSA singles remove in same
manner.
While holding down Red Release
Buttons on both Accessory Adapters
at sides of stroller, pull ICSA forward
and out of Receiver Sockets, keeping
alignment even, left to right, as you pull.
2. Slide Covers UP
Push to slide each Cover (at front of
stroller Accessory Adapters) up on
each side of stroller, covering each
Receiver Socket.
REMOVING RESTRAINT BELT
FROM STROLLER
1. Unscrew Captured Screws
Using a screwdriver, unscrew each
Captured Screw from each respective
stroller Anchor Nut.
18
OMB11