Infant Car Seat Installation; Graco ® Infant Car Seat Installation - Britax BOB Gear Duallie CS1011 Instructions Manual

INFANT CAR SEAT
INSTALLATION
Proceed to the section for your
brand of Infant Car Seat.
GRACO Infant Car Seat
®
INSTALLATION
Failure to properly install Infant Car
Seat on Infant Car Seat Adapter
may result in accident, injury or
death.
1. Prepare Stroller
Set parking brake, rotate canopy
towards handlebar, place Restraint Belt
ends to the sides of stroller seat (see
stroller owner's manual if necessary).
2. Align Infant Car Seat
Place Infant Car Seat "rear facing",
directly centered on top of ICSA,
aligning Groove Features of Infant
Car Seat with Front Spacers on ICSA.
3. Verify Infant Car Seat Latched
Properly
Push Infant Car Seat straight down
onto ICSA. "Look and listen for
Plastic Hook" on Infant Car Seat to
latch under main front tube on ICSA.
4. Verify Infant Car Seat Hooks are
Engaged
Push down on forward edge of Infant
Car Seat (end where infant's feet go);
listen for Steel Loops on Infant Car
Seat to engage over hooks on ICSA.
NOTE: For Snug Ride
Pull Infant Car Seat Release Handle
slightly while pushing down on front
edge of Infant Car Seat (end where
infant's feet go), then let go of Release
Handle to engage Steel Loops on
Infant Car Seat onto Hooks on ICSA.
5. Verify Infant Car Seat is Securely
Attached
Pull up on Infant Car Seat Carry
Handle to verify Infant Car Seat is
securely attached.
6. Secure Restraint Belt
Proceed to section titled "Securing
Restraint Belt" (pg.16).
CLICK
Models only;
®
13
OMB11