The scale uses two 1.5V AAA batteries (supplied). These batteries are located
internally and readily accessible.
Remove the battery cover on the bottom of the scale to remove the batteries.
The batteries must be disposed of at your local recycling point.
Replacing the battery
1. Remove the battery cover.
2.
Insert the batteries into the battery compartment
observing the correct polarity.
3. Attach the battery cover.
OPERATION
1. Place the scale on a hard and very flat surface. Avoid carpet or soft surface.
2. After installing the batteries, the display will show "888.8" briefly then show "0.0".
3. Select the weight unit kg or lb using the unit switch on
the back of the scale.
4. Step on the scale and stand still.
You will hear a beep and the scale display will flash to indicate that the
reading is accepted.
5. If there is no operation for a while, the scale will automatically switch off.
Warning indicators
When the display shows "C", please step the scale off then step it on again to
measure weight.
When the display shows "Lo", please replace the battery.
When the scale is overloaded, the display will show "Err". Please step off to avoid
damage.
2