Tenmars TM-101 User Manual

Tenmars TM-101 User Manual

Sound level meter
Hide thumbs Also See for TM-101:

Advertisement

TENMARS
TM-101
SOUND LEVEL METER
Rev.01
User's manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TM-101 and is the answer not in the manual?

Questions and answers

Summary of Contents for Tenmars TM-101

  • Page 1 TENMARS TM-101 SOUND LEVEL METER Rev.01 User’s manual...
  • Page 2 Thank you for using our Sound Level Meter. To ensure that you can get the most from it, we recommend that you read and follow the manual carefully before use. This unit conforms to the IEC651 Type2, ANSI S1.4 Type2 for Sound Level Meters. This Sound Level Meter has been designed to meet the measurement requirements of safety Engineers, Health, Industrial safety offices and quality control in various...
  • Page 3 9. Accuracy: ±1.5dB. 10. Dynamic range:50dB. 11. Alarm function:”OVER” is show when input is more than upper limit range. ”UNDER” is show when input is Less than lower limit of range. 12. MAX/MIN hold:Hold readings the Maximum and Minimum value. 13.
  • Page 4 21. Dimension: 280mm(L)x80mm(W)x32mm(H). 22. Weight: About 300g. (Including batteries) 23. Accessories: Instruction manual、carrying case 、9V Battery、 Screwdriver、3.5φ plug。 Name And Functions 1.Windscreen If you operate at wind speed over 10m/sec, please put protective accessories in front of the microphone. 2.Display 3.power switch The key turns the sound level meter ON or OFF 4.MAX/MIN hold switch...
  • Page 5 C:C-Weighting. For checking the low-frequency content of noise. (If the C-Weighted level is much higher than the A-weighted level, then there is a large amount of low-frequency noise) Time weighting select switch. FAST:for normal measurements. SLOW:for checking average level of fluctuation noise.
  • Page 6 Insert the microphone housing carefully into the insertion hole of the calibrator. Turn on the switch of calibrator and adjust the CAL potentiometer of the unit. The level display will indicate the desired level. Our products are all well calibrated before shipment. Recommended Recalibration cycle:1 year.
  • Page 7 MAX / MIN reading. “MAX” or ” MIN” symbol disappears. 6. Turn OFF the instrument and remove battery when not in use. NAME AND ADDRESS OF MANUFACTURE TENMARS ELECTRONICS CO., LTD. TAIPEI OFFICE: 6F, 586, RUI GUANG ROAD, NEIHU, TAIPEI, TAIWAN...

Table of Contents