Safety Barrier & Door Removal / Installation - Napoleon Oakville Series Installation Manual

finishing
EN
3.2 safety barrier & door removal / installation
WARNING
!
• Glass may be hot. Do not touch glass until cooled.
• If equipped with door latches that are part of a safety system, they must be properly engaged. Do not
operate the appliance with latches disengaged.
• Facing and/or fi nishing materials must not interfere with air fl ow through air openings, louvre openings,
operation of louvres, or doors/access for service. Observe all clearances when applying combustible
materials.
• Before door is removed, turn the appliance off and wait until appliance is cool to the touch. Doors are heavy
and fragile so handle with care.
A barrier designed to reduce the risk of burns from the hot viewing glass is provided with the
appliance and shall be installed.
1. Before the glass door can be removed, the safety barrier must be removed. Lift the safety barrier off the 4
side pins and remove from the appliance (Fig. 3-1 and 3-2).
2. Using the tool provided, pull the two top latches forward and upwards from the slow in the door (Fig. 3-3).
Ensure to keep one hand on the door at all times to prevent it from falling on the floor.
3. When both latches have been released, tilt the door forward and out of the bottom door retainer.
4. Reverse these steps to re-install the safety barrier and door. Ensure safety barrier is installed correctly.
14
W415-1799 / B / 06.11.19
Fig. 3-1
47.1
Fig. 3-2
Fig. 3-3