Using Your Refrigerator; Setting The Controls - Kenmore 7135 Series Use & Care Manual

Preview grab-n-go; standard;
Table of Contents

Advertisement

SETTING THE CONTROLS

Temperature
The Refrigerator Control is preset at 37°F (3°C) and
the freezer control is preset at 0°F (-18°C). These are
the recommended temperature settings for normal use
and conditions. Wait 24 hours for the refrigerator and
freezer to reach these temperatures.
The Refrigerator Temp Control range is from 33°F to
43°F (1°C to 7°C). The lower the setting, the colder the
refrigerator compartment will become.
The Freezer Temp Control range is from -7°F to 5°F
(-23°C to -15°C). The lower the setting, the colder the
freezer compartment will become.
NOTE: When changing control settings, wait 24 hours
before making additional adjustments. The controls are
set correctly when milk or juice is as cold as you would
like and when ice cream is rm. If the temperature in
either compartment is too cold or too warm, change the
setting one increment at a time. Wait 24 hours for the
change to stabilize before adjusting again.
Ice / Water
The dispenser dispenses water, cubed ice, or crushed ice.
Press the Ice/Water button repeatedly to illuminate the
icon for the desired dispenser mode.
NOTE: The dispenser will not operate when either of the
refrigerator doors is open.
NOTE: If the Control Lock LED icon is illuminated, the
dispenser will not work. Disable the Control Lock to use
the dispenser again.
CAUTION
The control display is operated by touch.
Excessive moisture on the display may cause a
malfunction. Please keep the display clean and dry.
Connect to potable water supply only.

USING YOUR REFRIGERATOR

19
Air ow
Be sure not to block vents while loading food into the
refrigerator. Doing so will restrict air ow and may cause
the refrigerator temperature to become too warm or
cause interior moisture buildup. (See air ow diagram
below.)
Accela Ice
When you touch the Accela Ice button, the LED will
light up and will remain on for 24 hours.
The function will automatically shut o after 24 hours.
You can stop this function manually by touching the
button one more time.
This function increases both ice making and freezing
capabilities.
Water Filter Reset
When the "Change Water Filter" text lights up, change
the water lter. After changing the water lter, press
and hold
button for three seconds to turn the
indicator light o . You need to change the water lter
approximately every six months.

Advertisement

Table of Contents
loading

This manual is also suitable for:

7035 series

Table of Contents