Table of Contents
Advertisement
REMOVING AND REPLACING
REFRIGERATOR DOORS
WARNING
Excessive Weight Hazard:
Use two or more people to remove and install the
refrigerator doors. Failure to do so can result in back
or other injury.
WARNING
Electrical Shock Hazard
Disconnect the electrical supply to the refrigerator
before installing. Failure to do so could result in
serious injury or death.
Do not put hands, feet or other objects into the air
vents or bottom of the refrigerator. You may be
injured or receive an electrical shock.
Removing the Left Door
1 The water supply is connected to the upper right part
of the rear surface of the refrigerator. Remove the ring
in the joint area. Hold the water supply connection
and gently push the collet (1) to detach the water
supply line (2) as shown.
Remove the screw (1) from the hinge cover at the top
of the refrigerator. Lift the hook (not visible), located
at the bottom of the front side of the cover (2) with a
at-heat screwdriver.
3 Remove the cover and pull out the tube (1).
5 Lift the door from the middle hinge pin and remove
Collet
NOTE: Place the door, inside facing up, on a
nonscratching surface.
NOTE
Disassembling/Assembling the Water Lines
13
REFRIGERATOR INSTALLATION
Disconnect all wire harnesses (2). Unscrew the ground
wire (3).
Rotate the hinge lever counterclockwise (1). Lift the top
hinge (2) free of the hinge lever latch.
Hinge Lever Latch
(1)
CAUTION
When lifting the hinge free of the latch, be
careful that the door does not fall forward.
the door.
Collet
Tube
Insert line
Clip
(2)
(Correct)
Advertisement
Table of Contents
