Unpacking The Projector - Barco UDX Installation Manual

Only ever use the manufacturer's recommended cleaning kit which has been specifically designed for
cleaning optical parts, never use industrial strength cleaners on the projector's optics as these will degrade
optical coatings and damage sensitive optoelectronics components. Failure to take suitable precautions to
protect the projector from the effects of persistent and prolonged air contaminants will culminate in extensive
and irreversible ingrained optical damage. At this stage cleaning of the internal optical units will be
noneffective and impracticable. Damage of this nature is under no circumstances covered under the
manufacturer's warranty and may deem the warranty null and void. In such a case the client shall be held
solely responsible for all costs incurred during any repair. It is the clients responsibility to ensure at all times
that the projector is protected from the harmful effects of hostile airborne particles in the environment of the
projector. The manufacturer reserves the right to refuse repair if a projector has been subject to knowingly
neglect, abandon or improper use.
Main Power requirements
The UDX operates from a nominal mono phase power net with a separate earth ground PE.
Power requirements : 120-160V / 200-240V (+/-10%), 20A, 50-60 Hz
The power cord required to connect the projector with the power net is delivered with the projector.
Projector weight
Do not underestimate the weight of the UDX. The projector weights about ±92 kg (±202 lbs) without lens. Be
sure that the pedestal on which the projector has to be installed is capable of handling five (5) times the
complete load of the system.

2.2 Unpacking the projector

What has to be done ?
The projector is delivered in a cardboard box on a pallet and is secured with banding and fastening clips.
Furthermore, to provide protection during transportation, the projector is surrounded with polymeric foam.
Once the projector has arrived at the installation site, it needs to be removed from the box and pallet in a safe
manner, without damaging the projector.
After unpacking let the projector acclimatize to a room temperature between 10°C (50°F) and 40°C
(104°F). Neglecting this may result in a start up failure of the Light Processor Unit.
Required tools
cutter knife
How to unpack
1. Remove the banding around the cardboard box and open the box. Do this by releasing the fastening clips as
illustrated.
Installation preparations
R5906113 /08 UDX 23