Lincoln Electric POWERTEC 205C Series Operator's Manual page 9

WARNING
Spot Timer has no effect in 4-Step Trigger Mode.
23. Slow-Blow Fuse, F1: Shuts off the supply power
when the current exceeds 2A in primary cable. After
the fuse burns out, it must be replaced with a new
one. (See "Spare Parts" chapter).
POWERTEC
205C
Slow-blow
2A
fuse , F1
24. Slow-Blow Fuse, F2: Shuts off the supply power
when the current exceeds 6,3A in secondary cable.
After the fuse burns out, it must be replaced with a
new one. (See "Spare Parts" chapter).
POWERTEC
205C
Slow-blow
6,3A
fuse , F2
Welding Cables Connections
Insert the plug of the work lead into the socket [7] or [8].
The other end of this lead connects to the welding piece
with the work clamp.
Connect the necessary gun for GMAW, FCAW-GS or
FCAW-SS process to the Euro Socket [6]. Contact tip
and gun's liner must be adjusted to the type and
diameter of using wire.
Wire Spool Loading
Wire spool type S300 and BS300 cab be installed on the
wire spool support [16] without adapter.
Wire spool type S200, B300 or Readi-Reel® can be
installed, but the applicable adapter must be purchased.
The applicable adapter can be purchased
separately(see "Accessories" chapter).
Wire Spool Type S300 & BS300 Loading
WARNING
Turn off the power source while mounting electrode wire.
28 27
Figure 10.

Turn the machine off.

Open the right side panel.

Unscrew the Locking Nut [25] and remove it from the
Spindle [27].
English
255C 305C
2A 2A
255C 305C
6,3A 6,3A
26
25

Place the spool type S300 or BS300 [26] on the
Spindle [27] making certain the Spindle Brake Pin
[28] is put in the hole in back side of spool type S300
or SB300.
Position the spool type S300 or SB300 so that it will
rotate in a direction when feeding so as to be de-reeled
from bottom of the spool.

Re-install the locking nut [25]. Make sure that the
locking nut is tightened.
Wire Spool Type S200 Loading
Turn off the power source while mounting electrode wire.
28 27

Turn the machine off.

Open the right side panel.

Unscrew the Locking Nut [25] and remove it from the
Spindle [27].

Place the adapter of spool type S200 [29] on the
spindle [27] making certain the spindle brake pin [28]
is put in the hole in back side of the adapter [29]. The
adapter of spool type S200 can be purchased
separately (see "Accessories" chapter).

Place the spool type S200 [31] on the spindle [27]
making certain that the adapter brake pin [30] is put
in the hole in the back side of the spool.
Position the spool type S200 so that it will rotate in a
direction when feeding so as to be de-reeled from
bottom of the spool.

Re-install the locking nut [25]. Make sure that the
locking nut is tightened.
6
WARNING
WARNING
29
30
31
25
Figure 11.
WARNING
English