Assembly Instructions - DM Industries Portable Spa Owner's Manual

1. PLACE BOTTOM PAD
Please see SITE SELECTION: Structure
2. STRETCH OUT LINER.
3. SET UP WALLS
4. INSTALL THE LINER
a) Note that the liner has a patterned side. Place the liner so that
the patterned side faces the inside of the spa .
b) Note that the therapy module, the liner seam, the belt spindles,
and the seat with the punched hole, need to be aligned for the
therapy module to cover the seam and the belt spindles and for
the cover straps to fall in the center of the wall sections. All seats
have a knockout whole. Use a screwdriver to remove the hole
cap in the seat that will be located under the therapy module.
c) Choose location of the therapy module, taking into
consideration accessibility and electrical requirements. Refer to
SITE SELECTION
d) Place the liner seam in the center of the wall section you would
like to put the therapy module on.
e) Stretch the liner over the top rim of the spa. Stretching the liner
into its final position will take about five minutes and may require
three or more persons.
5. INSTALL THE TOP BAND
liner seam. Inline with only the seat suction hole.
6. INSERT THE SEATS,
with the liner seam. To assist in the installation of the seats, it may
be necessary to position 2 seats like a pyramid (see diagram
below). Gently press down on the apex and they will all register in
place.

ASSEMBLY INSTRUCTIONS

on a clean, smooth, level
on page 4.
If liner is stiff, warm in the sun.
and install locking pins.
on page 4.
locating the belt spindle at the
BELT
TO TIGHTEN AND TURN
USE 3/8" BOX WRENCH
SPINDLE
BOLT
aligning the seat with the punched hole
surface.
1
3
4a
4b
WALL SECTION
5
6
PAGE 6
SEAT
ASSEMBLY
LOOKING DOWN
KNOCK-OUT HOLE WHERE
THERAPY MODULE SUCTION
IS TO BE INSTALLED
SEAM
PIN
SPA WALLS
BENCH
ALIGN
BENCH
TO WALLS
LOCATION