Step Assembly Instructions; Optional Accessory - DM Industries Portable Spa Owner's Manual

STEP ASSEMBLY INSTRUCTIONS (Optional Accessory)
Parts Check List:
(2) Side Panels
(2) Step Treads (one curved, one straight)
(1) Strip of Foam Squares
1. USING SHARP KNIFE,
two locking wedges off the ends of the steps and save.
(see figure 1).
2. LAY ONE OF THE SIDE PANELS
DOWN.
Push the end of the step into the
openings on the side panel making sure the front
edge of the step is flush with the front edge of the
side panel. Repeat for second step. (See figure 2)
Note: top step is curved.
3. SECURE EACH STEP
in between the side panel and the top surface of the step. (See
figure 3).
4. PEEL OFF A FOAM SQUARE
apply one to each of the bottom four corners to prevent
the step from slipping. (See figure 4).
carefully cut the
by tapping a locking wedge
and
PAGE 9
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4