Operation; Connecting The Pump Suction Line; Priming The Pump; Testing The Gfci - DM Industries Portable Spa Owner's Manual

CON NECTI NG TH E PU M P
SUCTION LI NE
IMPORTANT
TIGHTEN UNIONS BEFORE
INSTALLING UNIT INTO SPA
UNION
"O"-RING TIED
TO PIPE FOR
SHIPPING ONLY
SUCTION
PIPE
REMOVE O-RING TIED TO PIPE FOR SHIPPING AND INSTALL
THE "O"-RING INTO THE GROOVE ON THE UNION OF THE
SUCTION PIPE UNION. MATE THE UNION TO THE PUMP AND
ROTATE CLOCKWISE UNTIL SNUG. HAND TIGHT ONLY.

PRIMING THE PUMP

1. Fill the Voyager till the water is approximate-
ly 4" over the jets. Do not overfill.
2. Remove the
access door from
the module and
locate the prim-
ing hose system.
3. Remove the
valve cap.
JET BUTTON:
Controls Hydro jets
• Low Speed
• High Speed
LED DISPLAY
• Off
Shows Time
and Temperature
PROGRAM "PROG" BUTTON
• Switches Display From Time
To Temperature and Vice Versa
• Initiates Temperature and Time Settings
if Held Down For 5 Seconds

OPERATION

HEATER
CONTROL
PACK
MOTOR
PUMP
"O"-RING

TOP SIDE DIGITAL CONTROL

VOYAGER LV15 TOP SIDE CONTROL
HEAT
PROG
See Next Page For Instructions
Note: the prim-
ing valve has an
open (inline),
closed (across)
valve handle.
4. Attach by threading onto the priming valve
the male to male hose adapter.
5. Connect your garden hose to the adapter.
6. Open priming valve (inline position) and
start the water flow from your hose.
7. Plug in the voyager GFCI protected cord and
follow start up and programming directions.
8. Once the pump "starts" and you note a con-
tinuous flow of water at the jets-the Voyager
priming phase is complete.
9. Shut off water to hose.
10. Close (across position) prime valve handle.
11. Replace valve cap.
12. Store for future use the

TESTING THE GFCI

Plug in the Ground
into a standard
of outlets on page 5 ).Now is a good time to test
the GFCI. Please do so as follows:
The GFCI is a very important safety device.
The GFCI shuts off the electricity in a fraction of a
second if there is a short anywhere in the system.
The GFCI plug fits conventional
outlets. It is recommended that the
tested prior to each use. Test as follows:
REMINDER: DO NOT USE AN EXTENSION CORD.
DOING SO MAY CAUSE DAMAGE THAT WILL
NOT BE COVERED UNDER THE WARRANTY.
AM
PM
PAGE 10
adapter.
Fault Circuit Interrupter
110V-15A outlet (See correct type
110V
UP BUTTON
• Raises Temperature
• Forwards Time
• Reverts to Factory Defaults
(Temperature = 102°F - Time = 12PM)
If Held Down For 5 Seconds
DOWN BUTTON
• Lowers Temperature
• Sets Back Time
• Re-Boots System
If Held Down For 5 Seconds
(GFCI)
GFCI be
AM/PM
Indicator