NOMA Arctic Owner's Manual page 7

· Align blade holes and attach blade with blade screws
and washers. Before securing screws permanently,
repeat with remaining blade. Securely tighten all screws.
(Fig. 6).
IMPORTANT: Tighten blade screws twice a year.
· Remove 1 screw from motor plate on underside of motor
and partially loosen the other 2 screws.
· Align slotted holes in fitter plate with loosened screws in
motor plate, allowing molex to come through centre hole
in fitter plate. Twist fitter plate to lock. Re-insert screw that
was previously removed and securely tighten all 3 screws with
a crosshead screwdriver (Fig. 7).
· Remove 3 screws from underside of fitter plate.
· Connect blue wire from motor assembly to black wire from the
LED light kit. Connect white wire from motor assembly to white wire
from LED light kit. Make sure molex connections snap together
completely (Fig. 8).
· Gently push up on glass shade and turn to the RIGHT (clockwise)
until it slides completely into place (Fig. 9).
· NOTE: Pull down VERY GENTLY on glass shade to make sure that
glass shade is secure.
Rib of the blade
(this side is downward)
Motor plate
Molex connection
5
Fig. 6
Fig. 7
!
Fig. 8
Fig. 9