IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a piece of exercise equipment. Be sure to read the entire manual before you assemble or operate your machine. In particular, note the following safety precautions: 1.
PARTS LIST Q’TY DESCRIPTION Main Body 1 PC Front Stabilizer 1 PC Rear Stabilize 1 PC Front Post 1 PC Handlebar w/Grip 1 PC Computer 1 PC Seat Post 1 PC Seat 1 PC Left Pedal 1 PC Right Pedal 1 PC Adjustment Knob 1 PC...
ASSEMBLY STEPS 1. Attach the Front Stabilizers (2) and the Rear Stabilizer (3) to the Main Body (1), using 4 sets of M10x80mm Carriage Bolts (15), Washers (16) and Domed Nuts (17). 2. Take the Front Post (4) and join the Middle Computer Wire (23) with Lower Computer Wire (24).
NOTE FOR CONNECTING CABLES AND WIRES Please follow the steps to assemble the cable and wire. This is main doing when assembly handlebar post with main body. Step a. Prepare to connect cable and Step b. Slide the cable wire into the slot of Computer wire.
Page 8
3. Fix the Handlebar (5) to the Front Post (4) and tighten with 2 sets of M10x20 (19) and Arc Washers (20)., then use a L type knob(28) to tight the handlebar(5). 4. Fix the Seat (8) to the Seat Post (7) using 3 sets Nylon lock Nuts (14) and Washers (13) & (12), then insert into the Main Body (1).
5. The Left and Right Pedal (9) & 10) are marked "L" and "R". Connect them to their appropriate Crank Arm (27). The right pedal is on the right hand side of the cycle as you sit on it. Note that the right pedal should be threaded on clockwise and the left pedal on counter-clockwise.