Electrical I/O - Ransburg Pulsetrack 2 Service Manual

Master Overspeed Output
A 24VDC discreet output exists at breakout
terminal J3-C23 to indicate when an overspeed
fault occurs on any rotator. Using this output in
conjunction with the individual rotator fault output it
is possible to remotely determine on which rotator
the overspeed fault occurred. Maximum output
current from this output is 250mA.
Master Fault Output
A 24VDC master fault indicator exists on the front of
the control panel that is lit any time a fault occurs.
This active high output is also available remotely
at breakout terminal J3-C24. Thus, this discreet
output puts out 24VDC when a fault occurs. Max-
imum output current from this output is 250mA.
TABLE 4 - ANALOG OUTPUT SETTINGS
Rotator Jumper Setting
1 E6 on Pins 1 & 2
2 E5 on Pins 1 & 2
3 E4 on Pins 1 & 2
4 E3 on Pins 1 & 2
5 E2 on Pins 1 & 2
6 E1 on Pins 1 & 2
TABLE 5 - ELECTRICAL I/O
Breakout Terminal
J2-A1
J2-A2
J2-A3
J2-A4
J2-A5
J2-A6
J3-C15
J3-C16
J3-C17
J3-C18
(Continued On Next Page)
0-10VDC Setting
Dipswitch 7
OFF
OFF
OFF
OFF
OFF
OFF
Type
4-20mA/0-10VDC
4-20mA/0-10VDC
4-20mA/0-10VDC
4-20mA/0-10VDC
4-20mA/0-10VDC
4-20mA/0-10VDC
Active Low (Maintained)
Active Low (Maintained)
Active Low (Maintained)
Active Low (Maintained)
Brake Outputs (Optional, Bells Only)
24VDC brake outputs are located at breakout ter-
minals J3-C25 through J3-C30. For bell systems
configured with the brake option, these outputs
send 24VDC to the brake solenoids when bell
speed is decreased and/or disabled.
4-20mA Setting
Jumper Setting
E6 on Pins 2 & 3
E5 on Pins 2 & 3
E4 on Pins 2 & 3
E3 on Pins 2 & 3
E2 on Pins 2 & 3
E1 on Pins 2 & 3
Description
Rotator 1 Analog Speed Setpoint Input
Rotator 2 Analog Speed Setpoint Input
Rotator 3 Analog Speed Setpoint Input
Rotator 4 Analog Speed Setpoint Input
Rotator 5 Analog Speed Setpoint Input
Rotator 6 Analog Speed Setpoint Input
Rotator 1 Enable Input
Rotator 2 Enable Input
Rotator 3 Enable Input
Rotator 4 Enable Input
Dipswitch 7
ON
ON
ON
ON
ON
ON