Table of Contents
Advertisement
The control panel is preconfigured for 115 VAC or
230 V AC depending on the model number. Refer
to the "Parts Identification" section of this manual
and the product specification label located on the
control panel.
Figure 4: AC Input Power Connections
FIBER OPTIC CABLE
(See Figure 5)
Remove the fitting from the fiber optic input port
(FO1 - FO6) on the side of the control panel and
slide over one end of the fiber optic cable. Open
the control panel door. Insert the end of the fiber
optic cable through the input port fitting and into
the hole of the black rectangular fiber optic recep-
tacle on the fiber optic receiver module. Tighten
the screw of the fiber optic receptacle onto the flat
of the cable extension and secure the fitting on
the side panel. Route the fiber optic cable to the
rotator and connect the other end of the cable to
the fiber optic input fitting of the rotator.
The fiber optic cables are integrated into ¼" tubing
for mechanical protection. A minimum bend radius
of 3" is required. Care must be taken to prevent
kinking for protection of the fiber optic cables.
Avoid exposure of the cable ends to chemicals
such as paint or solvents. Exposing the cable
ends to such chemicals will cause damage and
can severely reduce the ability of the cable to
transmit light.
Figure 5: Fiber Optic Cable Installation
PNEUMATIC
CONNECTIONS
(See Table 2)
All pneumatic connections are made to the right
side of the PulseTrack 2 control panel. System
components should be installed to minimize the
length of pneumatic control lines. This will max-
imize the rotator speed control response. Tubing
may exceed the maximum lengths as indicated in
the "Specifications" in the "Introduction" section of
this manual dependent on the specific installation
requirements; however, this could degrade overall
speed control performance.
Advertisement
Table of Contents
