Table of Contents
Advertisement
SHUTTING DOWN
1.
After each use, if you
have
applied chemicals, place chemical
hose
into
conta iner of clean water
and draw
clean
water through
chemical
injection system to
rinse
system thoroughly.
CAUTION:
Risk
of
property
damage. Failure to
do so cou ld cause damage to the
pump.
MAINTENANCE
A
WARNING:
Risk
of
burn haz-
ard. When per-
forming maintenance,
you
may
be
exposed
to hot
surfaces, water
pressure or moving parts
that
can
cause serious
injury
or death.
A
WARNING:
Risk
of
fire
hazard.
Always discon-
nect, spark plug wire,
let the engine
cool
and
release
all water
pressure
before
performing
any
maintenance
or repair.
The
engine contains flam-
mable
fuel.
Do
not
smoke or work
near open
flames
while
performing
maintenance.
To
ensure efficient operation and lon-
ger
life
of
your pressure washer, a rou-
tine
maintenance schedule
should
be
prepared
and
followed
.
If the
pressure
washer
is
used
in
unusual conditions,
such as high-temperatures or dusty
conditions, more
frequent
maintenance
checks will
be
required
.
PUMP
The pump
on th is
unit
is maintenance
free
and
requires no
oil,
if
there is a
problem
with
the pump contact an
Authorized
Service
Center.
2.
Move
the engine on/off
switch
to
the
off
posiition,
(If
the
mark
of
switch
is 1 and 0,
put
the switch to 0 position).
CAUTION:
Risk
of
property
damage.
NEVER
turn the water
off
with the engine
running.
3.
Turn
water source off.
4.
Pull
trigger on spray gun
to
relieve any water
pressure
in hose
or spray gun.
5.
See Storage section
in
this man-
ual for proper storage
procedures.
NOZZLE CLEANING
If
the nozzle becomes clogged with
foreign materials, such as dirt, exces-
sive pressure
may
develop.
If
the
nozzle becomes partially clogged or
restricted,
the pump pressure
will
pul-
sate. Clean the
nozzle
immediately
using the nozzle
kit supplied
and the
following
instructions:
1.
Shut off the
pressure
washer and
turn
off
the
water supply.
2.
Disconnect spark plug wire to
ensure
the
unit
will
not start
while
performing maintenance.
3.
Pull
trigger on gun handle to
relieve any water
pressure.
4.
Disconnect the wand
from
the
gun.
5.
Remove the nozzle from the end
of
the
wand
with
a 2mm allen
wrench as shown.
6.
Clean
the nozzle
using the nozzle
cleaner provided or a stra ightened
paper clip.
Insert into
the nozzle
end and work
back
and forth
until
obstruction is
removed.
7.
Direct water supply
into
nozzle
end to backflush
loosened
particles for 30
seconds.
liiiiiiiiiiiiiiBmc:::>
8.
Reconnect spark
plug
wire.
25
Hide quick links:
Advertisement
Table of Contents
