Maintenance - PowerWasher TN-1200 Operator's Manual

-
3. Remove the suction tube from the wax bottle and rinse off the surplus wax
from·~-=··
.vehicle under low pressure. NOTE- IF SURPLUS WAS IS NOT REMOVED, A HAZ
FINISH MAY RESULT.
4. Wipe dry to reduce water spotting
4.6 END OF OPERATION
When you have completed use of the soap/wax application, remove bottle and flush
clean water through the tube until it is thoroughly cleaned.
NOTE: Failure to clean properly will cause the injection system to become clogged and
inoperable.
• Stop the cleaner by pressing the on/off button.
• Disconnect electrical plug.
• Turn off water and depressurize unit by squeezing trigger.
WARNING
WARNING: Turn off water supply and squeeze trigger to depressurize
the unit. Failure do so could result in personal injury due to discharge
of high pressure water.
• Disconnect the high pressure discharge hose and the water inlet hose
5.0 MAINTENANCE
5.1 CONNECTIONS
Connections on PressureWasher hoses, gun and spray wand should be cleaned
regularly and lubricated with grease to prevent leakage and damage to the
o-rings.
5.2 NOZZLE
Clogging of the nozzle causes the pump pressure to be high and possibly a distorted
spray pattern. Cleaning is immediately required.
1. Separate the wand from the gun.
2. Clear the nozzle with the nozzle cleaner.
CAUTION
CAUTION: The nozzle cleaner must only be used when the spray
wand is disconnected from the gun or personal injury could result.
------------------------------- 10 -------------------------------