Fishman SONITONE Installation Manual

SONITONE for GUITAR
INSTALLATION GUIDE
www.fishman.com
Read Me First!
Installation of this product is a straightforward
procedure, but we recommend this job only if you
are an experienced repair technician.
Saddle Slot:
Maximum E to E string spacing at saddle: 2.5"
(63.5mm)
Control mounting surface
The control module for this system was designed
to fi t in most guitars without modifi cation, but we
cannot guarantee a drop-in fi t with all instruments.
Before you begin installation, pre-fi t the control
module in the soundhole, but do not permanently
install at this time. Ideally, the controls should lie fl at
with the housing fl ush to the edge of the soundhole.
Preliminary
3
Drill a ⁄ " hole (2.4mm) in the saddle slot for the
32
pickup wire, no less than .100" (2.5mm) from nearest
string (fi gures 1, 2).
Seal the control module mounting surface
To ensure a strong and reliable bond, you must now
sand, clean and seal the underside of the soundhole
where the preamp will mount.
1. Sand the underside of the soundhole down to
bare wood. Take care to remove all residual lacquer,
polish and dirt.
2. Use mineral spirits to clean the sanded area.
Remove any excess oil, resin and dust from the
exposed wood. Let the area dry before proceeding
to the next step.
3. Seal the exposed wood with an appropriate
coating. Use only a coating that will bond the wood
fi bers and present a hard, uniform surface for the
adhesive. We recommend any of the following:
• Hide glue
• All purpose two-part epoxy
• Cyanoacrylate glue (higher viscosity,
non-instant type)
• Carpenter's glue
Let the area dry before proceeding to the next step.
Figure 1.
Figure 2.
1