Advertisement
SNCA-CFW1
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to following two
conditions:(1) this device may not cause harmful interference. and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B Peripheral,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment dose cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment has been tested to comply with the limits for a Class B peripheral, pursuant to
Subpart B of Part 15 of FCC Rules. Only peripherals (Network camera) certified (DoC) or verified
to comply with Class B limits may be attached to this equipment. Operation with non-certified
(DoC) or non-verified personal computer and/or peripherals is likely to result in Interference to
radio and TV reception. The connection of a unshielded equipment interface cable to this
Equipment will invalidate the FCC Certification of this device and may cause interference levels
which Exceed the limits established by FCC for equipment.
You are cautioned that changes or modifications not expressly approved by the party responsible
for compliance could void your authority to operate the equipment.
For mobile devices without co-location condition
FCC RF Radiation Exposure Statement:
This Transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
This device was not tested FCC RF Exposure (SAR) limits. User must be keep distance at least
20cm separation distance from the antenna to the body of the user or a nearby person. This
device cannot be used with handheld PDAs (personal digital assistants), desktop or laptop
computers. Use in other configurations may not ensure compliance with FCC RF exposure
guidelines.
Canadian Warning Statement:
This Class B digital apparatus complies with Canada RSS-210.
Cet appareil numérique de la classe B est conforme à la norme CNR-210 du Canada
Page 2 of 7
Advertisement
