Additional Safety Instructions For Batteries And Chargers - Black & Decker GPC1820L Original Instructions Manual

Hide thumbs Also See for GPC1820L:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
ENGLISH
Vibration
The declared vibration emission values stated in the technical
data and the declaration of conformity have been measured
in accordance with a standard test method provided by EN
60745 and may be used for comparing one tool with another.
The declared vibration emission value may also be used in a
preliminary assessment of exposure.
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level may
increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
Pruning
Before attempting to prune a tree, ensure there are not bylaws
or regulations that would prohibit or control the felling of
the tree.
Be aware of the direction a branch may fall. Consider all
u
conditions that may affect the direction of fall, including:
the length and weight of the branch to be cut
u
the intended direction of fall
u
any unusual heavy limb structure or decay
u
the presence of surrounding trees and obstacles,
u
including overhead lines
u
the intertwinement with other branches
u
the speed and direction of the wind
u
Consider access to the tree limb.
u
Tree branches are liable to swing towards the tree trunk. In
addition to the user, any bystander, building or object below
the branch is at risk of being struck by the branch.
Labels on tool
The following symbols are shown on the tool along with the
date code:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Do not expose the tool to rain or high humid-
ity.
Beware of falling objects. Keep bystanders
away.
Electrocution hazard. Keep at least 10 m
away from overhead lines.
6
(Original instructions)
Always wear head and eye protection.
Wear non-slip safety footwear.
To ensure continued safe operation, check
the chain tension as described in this manual
after every 10 minutes of use, and adjust back
to a clearance of 3 mm as required. Oil the
chain after every 10 minutes of use.
Direction of rotation of the chain.
Warning! Do not touch chain at the chip
ejection point.
Additional safety instructions for batteries and
chargers
Batteries
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not store in locations where the temperature may
u
exceed 40 °C.
Charge only at ambient temperatures between 10 °C and
u
40 °C.
Charge only using the charger provided with the tool.
u
When disposing of batteries, follow the instructions given
u
in the section "Protecting the environment".
Do not damage/deform the battery pack either by
u
puncture or impact, as this may create a risk of injury
and fire.
Do not charge damaged batteries.
u
Under extreme conditions, battery leakage may occur.
u
When you notice liquid on the batteries, carefully wipe the
liquid off using a cloth. Avoid skin contact.
In case of skin or eye contact, follow the instructions
u
below.
Warning! The battery fluid may cause personal injury or
damage to property. In case of skin contact, immediately rinse
with water. If redness, pain or irritation occurs seek medical
attention. In case of eye contact, rinse immediately with clean
water and seek medical attention.
Chargers
Your charger has been designed for a specific voltage. Always
check that the mains voltage corresponds to the voltage on
the rating plate.
Use your BLACK+DECKER charger only to charge the
u
battery in the tool with which it was supplied. Other batter-
ies could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
u
Have defective cords replaced immediately.
u

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ps1820st1

Table of Contents