Huawei AR200-S Series Quick Start Manual page 17

Huawei AR200-S Series Enterprise Routers
Quick Start Guide
4.
Installing the Chassis in a Cabinet or Rack
l When installing the AR200-S in a cabinet or rack, do not attach rubber pads to the chassis.
l The guide rails or trays are not necessary for the installation in a cabinet or rack because the
l It is recommended that you install the AR200-S with its front panel (providing indicators)
l Ensure that the air exhaust vent is not obstructed in any way. Otherwise, the chassis may
1.
2.
Issue 01 (2011-12-30)
Connect the power adapter. Place the power adapter on a nearby horizontal surface, but do
not hang it under the equipment.
CAUTION
If the rubber pads have been attached, remove them.
AR200-S chassis can be fixed by rack-mounting brackets. Customers need to buy the rack-
mounting brackets.
facing inside and its rear panel (providing interfaces) facing outside.
overheat.
Install two rack-mounting brackets. It is recommended that you install the rack-mounting
brackets close to the rear panel (providing interfaces).
Install two floating nuts on each side of the rack. The AR200-S chassis is 1 U high. The
mounting holes located on the rack-mounting brackets will be fixed to two mounting holes
on the rack.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Installation Product
12