Huawei AR200-S Series Quick Start Manual page 15

Huawei AR200-S Series Enterprise Routers
Quick Start Guide
Placing Chassis on the Desktop
Before placing the AR200-S on the desktop, attach rubber pads onto each of the four recessed
corner areas on the bottom of the chassis.
Wall-Mounting the Chassis
l When wall-mounting the AR200-S, do not attach rubber pads to the chassis. If the rubber
l It is inconvenient to connect ground cables and network cables after mounting the AR200-
l When connecting cables, do not make the front plastic panel of the chassis touch the ground
l It is recommended that you wall-mount the AR200-S with its front panel (with indicators)
l Use a ladder when mounting the chassis on the wall.
1.
Issue 01 (2011-12-30)
NOTE
All AR200-S series products have the same installation scenarios, installation methods, and cable
connections. This section uses AR207-S as an example.
CAUTION
pads have been attached, remove them.
S chassis on the wall. Therefore, it is recommended that you connect cables before mounting
the chassis on the wall. If the chassis has been mounted on the wall, hold the chassis when
connecting cables, preventing it from being detached from the wall. For the method of
connecting cables, see 2.3 Connecting
to avoid damage.
facing up and its rear panel (with interfaces) facing down.
Use the template on the last page to mark the location for the two mounting screws and the
upper, left, and right edges of the chassis on the wall.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Device.
2 Installation Product
10