Quick Reference Guide - Viper 552 Series Owner's Manual

QUICK REFERENCE GUIDE:

To lock/arm using your remote
s To arm the system press
nected). The LED will begin to flash. The Failsafe
vent the vehicle's starter from cranking if it has been installed. The ve-
hicle's horn (if connected) will honk and the parking lights will flash
once to confirm arming of the system.
To unlock/disarm using your remote
s To disarm the system press
connected). The Failsafe
cle's horn (if connected) will honk twice and the parking lights will flash
twice.
®
Disabling the Failsafe
s Turn on the ignition. Press and release the Valet
onds. The LED will stop flashing and the vehicle should start. Be sure to
check with the installer for the location of the Valet
To remote start the vehicle
s Press
and simultaneously. The parking lights will turn on (if
connected) and the vehicle will start and run for the programmed
amount of time.
®
To enter or exit Valet
s Turn the ignition to the "ON" position. Turn the ignition back off. Press
and release the Valet
light steadily if you have entered Valet
repeat the steps above. The LED will turn off when exiting Valet
To activate Panic Mode
s Press and hold
for 1.5 seconds.
To disable the remote start system
s To disable the remote start, move the shutdown toggle switch to the OFF
position.
Location of Shutdown Switch______________________________
2000 Directed Electronics, Inc.
©
for one second. The doors will lock (if con-
®
Starter Kill will pre-
for one second. The doors will unlock (if
®
Starter Kill will be deactivated and the vehi-
Starter Kill without a transmitter
®
switch within 10 sec-
®
switch.
Mode
®
switch within 10 seconds. The status LED will
®
Mode. To exit Valet
®
Mode,
®
Mode.
21