Operating Procedures; Site Selection - HWH 325 Series Operator's Manual

Choose a fairly level area for parking as leveling capabilities
with a two jack system is very limited. Maintain adequate
clearance in all directions for vehicle, specialty equipment,
room extensions, awnings, doors steps, etc. Vehicle may
IMPORTANT: If the vehicle is equipped with a room
extension read this section carefully.
If the vehicle is equipped with kick down jacks, the wheels
MUST be blocked securely.
NOTE: It is recommended to complete the Stabilizing
Procedure before operating room extensions. It is
recommended to retract room extensions before
retracting jacks.
1. Place gear selector in the parking position, apply park brake
and block tires securely.
NOTE: If the hand/auto park brake is not set, the panel
will turn on, but the system will not operate.
2. Turn ignition switch to "ON" or "ACCESSORY".
3. Push the "ON" button on the touch panel. The POWER ON
light will be lit.
4. Place pads under the jacks at this time if necessary.
5. Use EXTEND buttons to extend both jacks to the ground.
Each jack should lift the vehicle 1/2 to 1 inch to ensure
proper stabilizing. As each jack, extends 1/4 to 1/2 inch, the
corresponding red WARNING light on the touch panel will
come on.

OPERATING PROCEDURES

SITE SELECTION

ROOM EXTENSION PROCEDURES
STABILIZING PROCEDURE
move in any direction due to jack extending or retracting,
settling of jacks or vehicle, equipment malfunction, etc.
If parking on soft ground or asphalt paving, a wood block
or pad should be placed under each jack.
Refer to the vehicle owner's manual for proper operation of
room extensions.
IMPORTANT: Do not use a room extension support
when the vehicle is supported by the stabilizing system.
NOTE: Lifting the vehicle more with one jack than the
other may cause twisting stress on the vehicle.
7. Push the "OFF" button on the touch panel.
8. Turn the ignition switch off.
NOTE: The leveling system should be cycled once
a month or whenever the vehicle is used, to keep the
system in operating condition.
MP35.302C
19DEC06