Porsche 911 Manual page 199

Fig. 165: Adjusting the length of the carriers
b. Place long carrier A at the front and short
carrier B at the rear on the rotary holders G
and, at the same time, adapt to the vehicle
width by means of the moveable carrier
supports.
Ensure that the carriers are fitted in accord-
ance with the stickers on the underside of the
carriers.
c. Tighten the screws on the underside of the
carriers slightly.
Fig. 166: Tightening the screws on the underside of the
carriers
d. Remove the carriers and tighten the screws
on the underside of the carriers hand-tight
using the short side of the torque wrench.
e. Fit the handle of the torque wrench.
5. Place the carriers on rotary holders G (Fig. 165).
Roof Transport System
Fig. 167: Tightening carrier fastening screws
NOTICE
Risk of damage to the seals through pinching be-
tween roof and supports.
e Insert seals F in the support feet.
6. Screw in all 8 fastening screws on the carriers
using the torque wrench until flush with the sur-
face. Then tighten all 8 screws until the arrow
markings on the torque wrench are exactly
aligned.
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
197