Single Ups Installation - FSP Technology Proline 3/1 Series User Manual

Online ups
Table of Contents

Advertisement

15. External battery connector/terminal (only available for Long-run model)
16. Utility input terminal
17. Grounding terminal
18. Battery pack output circuit breaker
19. Bypass input circuit breaker

2-3. Single UPS Installation

Installation and wiring must be performed in accordance with the local electric laws/regulations and execute
the following instructions by professional personnel.
1)
Make sure the mains wire and breakers in the building are enough for the rated capacity of UPS to
avoid the hazards of electric shock or fire.
NOTE: Do not use the wall receptacle as the input power source for the UPS, as its rated current is less than
the UPS's maximum input current. Otherwise the receptacle may be burned and destroyed.
2) Switch off the mains switch in the building before installation.
3) Turn off all the connected devices before connecting to the UPS.
4) Prepare wires based on the following table:
Model
Input
10K
10KL
15K
15KL
20K
20KL
30K
30KL
NOTE 1: The cable for 10K/10KL should be able to withstand over 63A current. It is recommended to
use 8AWG or thicker wire for safety and efficiency.
NOTE 2: The cable for 15K/15KL should be able to withstand over 75A current. It is recommended to
use 6AWG or thicker wire for safety and efficiency.
NOTE 3: The cable for 20K/20KL should be able to withstand over 100A current. It is recommended to
use 6AWG or thicker wire for safety and efficiency.
NOTE 4: The cable for 30K/30KL should be able to withstand over 140A current. It is recommended to
use 4AWG or thicker wire for safety and efficiency.
NOTE 5: The selections for color of wires should be followed by the local electrical laws and
regulations.
5)
Remove the terminal block cover on the rear panel of UPS. Then connect the wires according to the
following terminal block diagrams: (Connect the earth wire first when making wire connection. Disconnect
the earth wire last when making wire disconnection!)
Wiring spec (AWG)
Output
8
8
8
8
6
6
6
6
6
6
6
6
4
4
4
4
Battery
Ground
8
8
8
6
6
6
6
6
6
4
4
4
8

Advertisement

Table of Contents
loading

Table of Contents