Operation - Laserworld Ecoline Series Manual

8. Operation

a. Connect the power cable to the device and then to the mains
b. Insert the key into the key switch and turn it „ON"
c. Connect the Interlock Connector with the Interlock interface
d. Press „ON" to switch the device on
8.1. Automatic, Stand-alone operation
Set the device to auto mode:
8.2. Music mode, Sound-to-light operation
Your device runs in music mode:
Control the music-sensitivity with the trim pot at the back panel. The LED is flas-
hing when the device is triggered.
8.3. DMX-512 mode
Switch 10 must be set to „off", the other switches are used for setting the DMX
address:
Connect a DMX controller to operate the laser.
Use the switches 1 - 9 to set the DMX address of the laser. Each switch represents a
number. To define a number use the preceding number and multiply it by 2:
Switch 1 2
Number 1 2
3 4 5
4 8 16
6 7 8
32 64 128
9 10
256 Mode Switch