Device Connections & Setting Opptions; Operation - Laserworld Ecoline Series Manual

Manual: Ecoline Series EL-160RGB Micro
6. Device connection & setting opptions
Model type
On / off switch
& modes
Connection for
power supply

7. Operation

7.1 Power supply
Connect your EL-Micro with the line adapter and connect it with the power supply. Please
make sure that you are using the correct voltage. False voltages could destroy the device.
Please use the voltage specified at the end of this manual. Don't focus the front of the laser on
people while installation.
7.2 Switch on / off
Set the switch on the back side of the laser on "On" to switch the device on or "Off" to switch
the device off. The auto mode is active when "On" is set. Please disconnect the device from the
power supply if you don't need it for a longer period.
7.3 Stroboflash
Set the switch on "Stroboflash" to activate the flash effect. The laser output will be interrupted
in certain intervals. Fine tuning will be made by the trim pots.
page 6 / 15
Please read manual before operation
EL-160RGB Micro
Sensivity control
of the music mode
Control of the flashing
frequency in strobo
mode
Micro
Speed control
of the effect
movements
Warranty label
Output
power &
wavelength,
etc.