Table of Contents
Advertisement
Connecting 2120 Nodes and DACRs
(RETROFIT APPLICATIONS ONLY)
Introduction
In this Chapter
Chapter 5
This chapter describes how to connect 2120 nodes and DACRs (Digital Alarm
Communicator Receivers) to an IMS using the existing RS-232 Serial Port.
Note: To connect 2120 nodes using the Multiport card, refer to the SLI
Multiport Option - Installation Instructions, Publication 574-097.
Note: A SPC2120 and DACR cannot operate on the same PC.
This chapter discusses the topics listed in the following table. Refer to the page
number listed after the topic for information on that topic.
Hardware Requirements
Connecting the 2120 Nodes to the IMS
Connecting DACRs to the IMS
5-1
Topic
See Page #
5-2
5-3
5-5
Advertisement
Table of Contents
