Cooking Rice; After Use - Breville VTP053 Instruction Booklet

cooking rice

Make sure your multi cooker is switched off, unplugged at the mains supply
socket and is fully cooled before assembling or disassembling. During use the
glass lid, removable bowl and cooker body will get very hot. Always handle with
care and use oven gloves.
Beware of hot steam escaping from the vent hole in the glass lid.
Always check that your rice is thoroughly cooked before serving.
1. Set the mode selector switch to OFF. Place the removable bowl inside your multi
cooker's base. Ensure the bowl is positioned correctly before continuing.
2. Use the supplied measure to measure the required quantity of rice into a container
for washing. For accuracy, always fill the measure with rice until it is level with the
surface of the measure. Don't use heaped measures. For quantities see the rice
cooking guide on page 14.
3. Wash the rice thoroughly under cold running water. This will remove the excess
starch from the rice and produce better results when cooking. Add the washed rice to
the removable bowl.
4. Using the supplied measure, add the required quantity of water to the removable
bowl. Spread the rice evenly across the bottom of the bowl. The minimum quantity is
150g and the maximum is 900g.
5. Place the glass lid onto your multi cooker.
6. Plug your multi cooker into a suitable mains supply socket. The POWER light will
flash.
7. Move the mode selector switch to the RICE position. After a few seconds, the
POWER light will stop flashing and remain on as your multi cooker heats up.
When the rice is cooked, the KEEP WARM light will illuminate.
For best results, allow your rice to stand for 10-15 minutes in your multi cooker on the
keep warm setting before serving.
After the rice has rested for 10 to 15 minutes, remove the lid and stir the rice gently with
the serving spoon. If the rice is not done, re-cover and let it stand in the keep warm mode
until it is ready. Do not leave your multi cooker on the keep warm setting for longer than
one hour.

After use

After use, set the mode selector to OFF and unplug your multi cooker from the supply
socket. Your multi cooker does not switch off automatically.