Advertisement

Guangdong Transtek Medical Electronics Co., Ltd.
Zone A, No.105 ,Dongli Road, Torch Development District,
Zhongshan,528437,Guangdong,China
User Manual
Blood Pressure Monitor
Thank you for selecting a TRANSTEK Blood Pressure Monitor.
Please read the user manual carefully and thoroughtly to ensure the safe
usage of this product,Keep the manual well for further reference in case
you have problems.
version:1.0
TMB-1583-S
Arm Type

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TMB-1583-S and is the answer not in the manual?

Questions and answers

Summary of Contents for TRANSTEK TMB-1583-S

  • Page 1 Blood Pressure Monitor TMB-1583-S Arm Type Thank you for selecting a TRANSTEK Blood Pressure Monitor. Guangdong Transtek Medical Electronics Co., Ltd. Please read the user manual carefully and thoroughtly to ensure the safe Zone A, No.105 ,Dongli Road, Torch Development District,...
  • Page 2: Table Of Contents

    CATALOGUE Table of Contents INTRODUCTION........................2 General Description Indications for Use Contraindications Measurement Principle Safety Information LCD Display Signal Monitor Components List BEFORE YOU START......................9 The Choice of Power Supply Installing and Replacing the Batteries Setting Date, Time and Measurement Unit Select the User MEASUREMENT........................14 Tie the Cuff...
  • Page 3: Introduction

    Indications for Use recycling the packaging materials of consumer goods. The Transtek Blood Pressure Monitor is a digital monitor intended for use in measuring blood pressure and heartbeat rate with arm circumference ranging from 22cm to 42cm(about 8¾˝-16½˝). It is intended for adult indoor use only.
  • Page 4 INTRODUCTION INTRODUCTION CAUTION CAUTION * This device is contraindicated for any female who may be suspected of, or is pregnant. * This device is intended for adult use in homes only. Besides providing inaccurate readings, the effects of this device on the fetus are unknown. * The device is not suitable for use on neonatal patients, pregnant women,patients with * Too frequent and consecutive measurements could cause disturbances in blood circulation implanted, electronical devices, patients with pre-eclampsia, premature ventricular beats, atrial...
  • Page 5 * If you have any problems with this device, such as setting up, maintaining or using, please contact the SERVICE PERSONNEL of Transtek. Don’t open or repair the device by yourself in the event of malfunctions. The device must only be serviced, repaired and opened by individuals at authorized sales/service centers.
  • Page 6: Monitor Components

    Replace the batteries whenever the below happens List shows 1.Blood Pressure Monitor 2.Cuff (Type BF applied part) The display is dim. (TMB-1583-S) ( 22cm~42cm) The display does not light up CAUTION Do not use new and used batteries together. 3. 4×AAA batteries 4.User manual...
  • Page 7: Setting Date, Time And Measurement Unit

    BEFORE YOU START BEFORE YOU START Setting Date, Time and Measurement Unit 4.Repeat step 2 and 3 to set the [MONTH] and [DAY]. It is important to set the clock before using your blood pressure monitor, so that a time stamp can be assigned to each record that is stored in the memory.
  • Page 8: Select The User

    BEFORE YOU START BEFORE YOU START Select the User . After UNIT is set,the LCD will display “donE” , then display 1.When the monitor is off , press and hold the MEM button all the setting you have done and then turn off. to enter user setting mode.
  • Page 9: Measurement

    MEASUREMENT MEASUREMENT Start the Measurement Tie the cuff 1.When the monitor is off, press the “START/STOP” button to turn Tie the cuff on your upper arm, then on the monitor, and it will finish the whole measurement. position the tube off-center toward the (Take user 1 for example) inner side of arm in line with the little finger.
  • Page 10: Data Management

    DATA MANAGEMENT DATA MANAGEMENT Recall the Records Delete the Records If you did not get the correct measurement, you can delete all When the monitor is off, results by following steps below. (Take user 1 for example) please press the “MEM” button to show the average value of the latest three records.If the records are less than three...
  • Page 11: Special Function

    INFORMATION FOR USER SPECIAL FUNCTION About the Lock Button Tips for Measurement The unnecessary keys’ touch will make the blood pressure Measurements may be inaccurate if taken in the following monitor turn on and waste electricity. To avoid this, you can circumstances.
  • Page 12: About Blood Pressure

    INFORMATION FOR USER ABOUT BLOOD PRESSURE Maintenance What are systolic pressure and diastolic pressure? Systolic Diastolic When ventricles contract and pump blood out of the In order to get the best performance, please follow the heart, the blood pressure reaches its maximum value blood entering blood discharging vein...
  • Page 13: Why Does My Blood Pressure Fluctuate Throughout The Day

    TROUBLESHOOTING ABOUT BLOOD PRESSURE This section includes a list of error messages and frequently asked questions for problems you may encounter with your blood Why does my blood pressure pressure monitor. If the product is not operating as you think it fluctuate throughout the should, check here before arranging for servicing.
  • Page 14: Specifications

    Contact Information up to 50hPa Measurement perimeter of For more information about our products, please visit www.transtek.cn.you can get About 22cm~42cm the upper arm customer service, usual problems and customer download, transtek will serve you Net Weight anytime.
  • Page 15: Complied Standards List

    Warning:Portable RF communications equipment (including peripherals such as antenna cables and external equipment - Part 1-11: General requirements for basic safety and antennas) should be used no closer than 30 cm (12 inches) to any part of the equipment TMB-1583-S, essential performance - Collateral standard: Requirements for medical including cables specified by the manufacturer.
  • Page 16: Emc Guidance

    EMC GUIDANCE EMC GUIDANCE Table 2 Table 3 Guidance and manufacturer’s declaration – electromagnetic Immunity Guidance and manufacturer’s declaration - electromagnetic Immunity IMMUNITY Radiated RF Test Band Service Modulation Modulation Distance (m) Immunity Test IEC 60601-1-2 Compliance level TEST IEC61000-4-3 Frequency (MHz) Test level...

Table of Contents