Operational Led Status Indicators; Behaviour Of The Status Indicators During The Boot-Up Process; Behaviour Of The Status Indicators When Resetting To Default Settings; Behaviour Of The Status Indicators During A Firmware Update - ADS-tec IRF2000 Series Instruction Manual

IRF2000 series - standard

6.2 Operational LED status indicators

6.2.1 Behaviour of the status indicators during the boot-up process

The boot-up process starts as soon as the device is supplied with power. The PWR LED illuminates
green and flashes slowly while the device is booting.

6.2.2 Behaviour of the status indicators when resetting to default settings

The Factory Default pushbutton is used to reset the firewall back to the default factory settings at any
time, independent of its configuration.
To reset the firewall to the default settings, the Factory Default pushbutton must be pressed prior to the
boot-up process and held down for approx. 10 seconds during the boot-up process. The PWR LED
flashes rapidly while resetting to factory settings.
As soon as the PWR LED lights up constantly, it is possible to access the web interface.

6.2.3 Behaviour of the status indicators during a firmware update

A firmware update can be performed via the web interface.
The PWR LED flashes rapidly during a firmware update of the firewall. The update procedure takes
•
a few minutes. Initialisation begins after the update procedure has been performed successfully.
The PWR LED flashes slowly during this phase.
During a firmware update of the WWAN module, the 3G/4G LED flashes yellow at a frequency of
•
5 Hz.
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
Doc v2.7 27