Door - Maintenance And Adjustment; Dismantling The Door; Adjusting The Door - Memmert BASIC Service Instructions Manual

19. Door – maintenance and adjustment

19.1. Dismantling the door

• Release the screws (5).
• Pull out the door (3) horizontally in the
direction of the arrow.
• When re-fitting the door, note the following:
• Apply thin Silicone grease to the moving
parts of the door hinges (see also Operating
Instructions "Maintenance")
• Place a special washer at the bottom door
hinge between excentric (4) and door.
• When re-fitting the door, ensure that the
adjusting notch of the excentric (4) is towards
the front.
• Replace the screws (5) and tighten them.

19.2. Adjusting the door

• The top part (6) of the door hinge can
be moved slightly in the direction of the
arrow after releasing two screws (7) on the top
or bottom of the door.
• The door can be adjusted after releasing the
socket screw (2) by rotating the excentric (4)
with a screwdriver.
• NOTE! Screw (2) is locked with adhesive.
It can be released by a sharp tug using a
hexagon socket key.
• Apply fresh adhesive to screw (2) and tighten it.
Details of excentric:
Excentric set to the front
factory-setting
4
page 19
1
4
5
6
Excentric set to the right,
the door is moved to the right
2
3
7
2
SERVICE - UIS