Grounding Instructions - Viking Built-In Convection Microwave Hood User Manual

GROUNDING INSTRUCTIONS

This appliance must be grounded. This microwave oven is equipped with
a cord having a grounding wire with a grounding plug. It must be plugged
into a wall receptacle that is properly installed and grounded in accordance
with the National Electrical Code and local codes and ordinances. In the
event of an electrical short circuit, grounding reduces risk of electric shock
by providing an escape wire for the electric current.
WARNING – Improper use of the grounding plug can result in a risk of
electric shock.
ELECTRICAL REQUIREMENTS
Check Installation Instructions for proper location
for the power supply.
The electrical requirements are a 120 volt
60 Hz, AC only, 15 amp. or more protected
electrical supply. It is recommended that a
separate circuit serving only this appliance be
provided.
The microwave oven is equipped with a 3-prong grounding plug. It must
be plugged into a wall receptacle that is properly installed and grounded.
DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE GROUND-
ING PIN FROM THE PLUG.
Note:
1. If you have any questions about the grounding or electrical instructions,
consult a qualified electrician or service person.
2. Neither Viking nor the dealer can accept any liability for damage to the
microwave oven or personal injury resulting from failure to observe the
correct electrical connection procedures.
RADIO OR TV INTERFERENCE
Should there be any interference caused by the microwave oven to your
radio or TV, check that the microwave oven is on a different electrical circuit,
relocate the radio or TV as far away from the microwave oven as feasible or
check the position and signal of the receiving antenna.
7