Midea FP-92LFC100GMTH-W2 User Manual page 11

INSTALLATION
Levelling the washing machine
Warning!
• The lock nuts on all four feet must be screwed tightly against the housing.
1.Check if the legs are closely attached to the cabinet. If not, please
turn them to their original position then tighten the nuts.
2.Loosen the lock nut then turn the feet until it closely contacts with the floor.
3.Adjust the legs and lock them with a wrench, make sure the
machine is steady
Connect Water Supply Hose
Warning!
• To prevent leakage or water damage, follow the instructions below.
Do not kink, crush, modify or cut the water inlet hose.
Connect the inlet pipe as indicated, There are two ways to connect the inlet pipe.
1.Connection between ordinary tap and inlet hose.
clamp nut
Loosen clamp nut
and four bolts
2.Connection between screw tap and inlet hose.
Tap with threads and inlet hose
1
Raise
1
Press the tap end
against the rubber ring
inside the clamp then
tighten the 4 screws.
2
Lower
2
slide bushing
Press slide bushing,
insert inlet hose into
connecting base
Special tap for washing machine
9 10
3
Lock nut
foot
3
Connection finished
slide bushing
4
4