Chapter Objective
Set the Monitor Type
Check and Change
the Display Resolution
Display Configuration
This chapter covers the following topics:
·
Set the Monitor Type
·
Check and Change the Display Resolution
·
How to Use the OSD Buttons
·
How to Use the OSD Buttons
·
Use the Auto Adjust Control
·
Change Monitor Settings with OSD
·
OSD Menus
The monitors are plug-and-play compliant devices. Your computer automatically
sets the monitor type. Additional setup is not required.
Flat panel monitors are fixed-resolution devices. The image looks best when the
monitors are operated at their native resolution. However, the monitors have
advanced scaling capabilities to make the display look as good as possible while
running in non-native modes.
These are the native resolutions of the monitors:
· 1550M: 1024x768
· 1750M and 1950M: 1280x1024
If you switch the resolution of your monitor from its native resolution, the
display may look slightly distorted due to the replication techniques used to fill
the full screen with an image.
To check or change your monitor's display resolution, access the Display settings
in the Control Panel on your computer.
TIP
A refresh rate of 60 Hz is optimal for LCD flat-panel displays.
Rockwell Automation Publication 6176M-UM001D-EN-P - December 2012
3
Chapter
25