QUAD Vena II Play User Manual page 6

INSTALLATION
Before making any connections to your high fidelity equipment make sure that all units in the system are switched off and
unplugged at the mains.
Mains Connections
The Mains On/Off switch is on the rear panel. Before connecting your QUAD equipment to the AC mains supply check and make
sure the voltage marked on the back matches your supply voltage.
Analog Signal Output Connections
Preamplifier Output
Vena II Play has one pair of unbalanced RCA outputs which can make Vena II Play operate as a preamplifier.
Connect an RCA cable between the unbalanced pre output of Vena II Play and the unbalanced input of a power amplifier or
associated equipment. Interconnectors should be of low-noise construction and fully screened to minimize hum and noise
transmission.
Loudspeaker Outputs
Vena II Play has two sets of loudspeaker outputs. They are independent for right and left stereo amplifier outputs.
Connect the Positive (+) RED terminals of the amplifier to the Positive (+) RED terminals of the loudspeakers. Connect the Negative
(-) BLACK terminals similarly. When connecting loudspeakers tighten the terminals securely by hand. Make sure there are no loose
strands of wires which could cause short circuits.
Headphone Output
Vena II Play has a stereo 6.3mm(1/4") jack on the front panel for connecting headphones Connecting headphones mutes the
audio signal to the loudspeakers. Vena II Play headphone output can be set up to 4.5V, users can select suitable output levels to
suit their headphones.
WARNING: Listening to music at high volume levels and for extended durations can damage one's hearing. In order to reduce the
risk of damage to hearing, one should lower the volume to a safe, comfortable level, and reduce the amount of time listening at
high levels. Headsets should comply with EN 50332-2 requirements (for GS certification).
6