Advertisement
2. Fasten two M5 screws through the chassis ears in the front side of the chassis to secure the AccuRAID
subsystem in the rack as Figure 3.
Hardware Connection Instructions
1. Power off all devices.
2. Connect the host connection cables. For mini-SAS models connect the SAS cables to the SAS HBA on
the server.
3. Connect the LAN cable to the local network. Make sure it is on the same network of the host
computer/server. Web based management can reach as long as they are on the same network.
4. Connect the power cable. Please make sure connect each redundant power supply with the power cables.
The use of UPS, uninterrupted power supply, is higher recommended.
5, Connect AccuSTOR Expansion JBOD system if desire. Please refer to below diagrams for connections.
Management Methods
There are three management methods to manage AccuRAID series, describe in the following:
Web browser based RAID Manager
Web browser based RAID manager provide access to RAID unit's status via any OS's web browsers.
Connect to the RAID unit's Ethernet port to network and you can access the information. The default setup
as below:
IP Address: DHCP (Display in the front LCD)
Web address: http://IP_address
Login name: admin
Default password: 0000
Console Serial Port
Use NULL modem cable to connect console port of the RAID subsystem.
The console setting is baud rate: 115200, 8 bits, 1 stop bit, and no parity.
Terminal type: vt100
www.sansdigital.com
|
info
sansdigital.com
|
phone 800 980 1988
@
Figure 3.
|
fax 626 322 3878
Advertisement
