Lamp Replacement - ViewSonic PJL6223 User Manual

Maintenance and Cleaning
When the projection lamp of the projector reaches its end
mode.
Note:
(p.25), or No show
CAUTION
the projector can become very hot.
CAUTION
When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may be
broken.
If replacing the lamp of a projector which has been installed on the ceiling, you should always assume that
the lamp is broken, and you should stand to the side of the lamp cover, not underneath it. Remove the
lamp cover gently. Small pieces of glass may fall out when the lamp cover is opened. If pieces of glass get
into your eyes or mouth, seek medical advice immediately.
Follow these steps to replace the lamp.
1
2
3
the lamp out of the projector by using the handles.
Replace the lamp with a new one and secure the three
4
Close the lamp cover and secure the screw.
5 Connect the AC power cord to the projector and turn
on the projector.
Reset the lamp replacement counter.
6

Lamp Replacement

Top Control
Lamp replacement icon
For continued safety, replace with a lamp of the
same type. Do not drop a lamp or touch a glass
bulb! The glass can shatter and may cause injury.
Off
CAUTION
Screw
Screw
Handles
Screw
LAMP REPLACE
indicator
Freeze
Screw