Access Control; Local - Dahua Villa VTO User Manual

Parameter
Audio
Control
Volume
Control
4.3

Access Control

This section introduces how to configure the lock, including unlock responding interval, open
door command, door sensor check time, first unlock command and door contact type.

4.3.1 Local

Step 1 On the main interface (Figure 3-1), select Local Setting > Access Control > Local.
Step 2 Configure parameters.
Parameter
Unlock Responding
Interval
Unlock Period
Door Sensor Check
Time
Description
the brighter the picture will be, and the smaller the darker.
Select On, and then the image is displayed with left and right
Mirror
side reversed.
Flip Select On, and then the image is displayed upside down.
Select Enable or Disabled to turn on or off each sound.
Miccrophone Adjust the value, and the larger the value is, the louder the
Volume VTO microphone volume will be.
Adjust the value, and the larger the value is, the louder the
Beep Volume
system volume will be.
Figure 4-4
Table 4-3 Local access control parameter description
Description
The time interval to unlock again after the previous unlock, and the
unit is second.
The time amount for which the lock stays open after unlock, and the
unit is second.
If you have installed door sensor, you need to configure the time
period, and If the unlock time exceeds the Door Sensor Check
Time, the door sensor alarm is triggered, and the alarm will be sent
to the management center.
Select the Enable check box, and the door will not be locked

Local
9