Table of Contents
Advertisement
16. Dec-Act. jack (output) - provides a +5 V signal during the decay phase
17. LED indicator – shows by its brightness the current envelope output
value during the decay phase, "green" at positive output values, "red" for
negative ones
18. Sustain controller – set the final value of the decay phase between
-100% (-5 V) und +100% (+5 V)
19. CV-Sus jack (input) - set by an external voltage of -5 V - +5 V (at middle
position of
und +200% (+10 V); decay becomes at >100% a second attack!
20. LED indicator – shows by its brightness the current envelope output
value during the release phase, "green" at positive output values, "red" for
negative ones
21. Release controller – set the release time between 100 µs to 20 seconds
22. 1 V/Dec. jack (input) – set by an external voltage the release time by a
sensitivity of 1 V/decade, positive/negative voltage -> faster/slower by a
factor of 10 per volt from the current state
23. CV-VCA jack (input) - controls by an external voltage between -5 V - +10
V the envelope amplitude between inverse (attack final value = -5 V) and
+10 V
24. VCA jack (output) - provides the VCA controlled
25. Env Out jack (output) - provides the envelope output with a fix +5 V
attack final value
26. Gate jack (input) – generates, caused by a 0 V -> +5 V transition, a +5 V
Gate signal of definite length at
definite delay time at
27. Gate O jack (output) – provides a +5 V Gate signal of definite length or by
a definite delay time in relation to the Gate input
28. G-Time controller – set the Gate length in Gate mode or the delay time in
delay mode, resp. between 50 µs to 10 seconds
29. 1 V/Dec. jack (input) – set by an external voltage the Gate length/delay
time by a sensitivity of 1 V/decade, positive/negative voltage ->
shorter/longer by a factor of 10 per volt from the current state
30. Gt/Del jack (input) – selects between Gate mode and Delay mode,
+5 V -> Gate, 0V -> Delay; is tied by a switching contact to +5 V and is
unused in Gate mode
31. LED indicator – lights up in Delay mode firstly "red", when a Gate signal is
incoming at
becomes active
(18)
) the final value of the decay phase between -200% (-10 V)
jack (27)
jack (26)
and changes to "green" when the Gate O at
CS-8 Series DTG Rev1.3, July 2020
(21)
jack (27) (Gate O)
-11-
(23)
envelope waveform
; or outputs it by a
(26)
(28)
jack (27)
Advertisement
Table of Contents
