Page 5
Adjust the height so the tilt knobs are in the middle of the fixture. This will make it easier to fit the softbox onto it. Attaching the Softbox Align the COL-1212 so the straps are on the side of the fixture. Open the adjustable corners.
Page 6
Spread the flaps open, and fit the opening of the COL-1212 on the fixture. Make sure the black inner border rests on the front of the light. Secure the straps by stretching them across the back of the fixture and attaching them to the touch- connect strips on the opposite side.
Page 7
COL-BOW For Light Fixtures with Bowens Accessory Mounts Remove the reflector from the Bowens mount. Open the zipper at the bottom of the cylinder, and insert the reflector through the opening. Attach the reflector to the light. The reflector will hold the cylinder in place.
Page 8
COL-CYL For Round LED Light Fixtures Align the cylinder so the notches are on the sides of the fixture. Fit the opening of the cylinder over the fixture. Secure the straps to the touch- connect pads.
Page 9
Unzip and remove the bottom panel to allow the light to shine directly down without diffusion. Attaching the Skirt to the Cylinder The Angler COL-CYLSK reversible skirt (sold separately) limits light spread on one side of the cylinder. Use the included clips to attach the skirt to the top and bottom rims of the cylinder.
One-Year Limited Warranty This Angler product is warranted to the original purchaser to be free from defects in materials and workmanship under normal consumer use for a period of one (1) year from the original purchase date or thirty (30) days after replacement, whichever occurs later. The warranty provider’s responsibility with respect to this limited warranty shall be limited solely to repair or replacement, at the provider’s...
Need help?
Do you have a question about the COL-1212 and is the answer not in the manual?
Questions and answers