Step 1; Step 2 - modway EEI-2263 Assembly Instruction

EEI-2263
ARMLESS CHAIR

STEP 1:

Remove the plastic covers which pre-install in the end of the Seat Frame (3) by using Allen Wrench (C).
Please put 1 piece of Leg (2) on a carpeted or padded area.
Insert Top Rail (1) and Seat Frame (4) into the Leg (2) as shown.
Insert 3 pieces of Bolt (B) from the pre-drilled holes on the bottom of the Top Rail (1) and Seat Frame (4) into each side
on the bottom of Leg (2).
Insert 2 pieces of Bolt (A) from the pre-drilled holes on the side rail of the Seat Frame (4) into each end of the Leg (2) as shown.
Do not fully tighten Bolts (A&B) at this step.
Repeat the same steps for the remaining 1 piece of Leg (2).
After checking the leveling for all connections, please use Allen Wrench (C) to tighten all Bolts (A&B) clockwise until secure.
The bottom of seat frame and legs
2
3
The bottom of seat frame and legs
2
3
Ax4 Bx6

STEP 2:

Carefully place the assembled chair at your desired position.
Put the Seat Cushion (4) and Back Cushion (5) to assembled chair frame as shown.
Customer Service 908-368-1025︱www.modwayfurniture.com
A C
2
C
3
B
Cx1
Assembly is completed. The chair is ready to enjoy now!
1
The bottom of top rail and legs
2
5
4
C
2
B
1
Hardware & Tool required
Page 2 of 2