modway Shore EEI-2264 Assembly Instruction

modway Shore EEI-2264 Assembly Instruction

Corner

Advertisement

EEI-2264
CORNER
Thank you for purchasing the MODWAY CORNER!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the corner, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approx assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
Component:
1
Top Rail
x1
5
Seat Cushion
Customer Service 908-368-1025︱www.modwayfurniture.com
7
2
4
2
Left Leg
x1
6
Back Cushion
x1

Hardware:

A
B
C
6
5
3
3
Right Leg
x1
Bolt M6x20mm
x4
Bolt M6x25mm
x6
Allen Wrench M4
x1
1
4
x1
Seat Frame
7
Side Cushion
Page 1 of 2
x1
x1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Shore EEI-2264 and is the answer not in the manual?

Questions and answers

Summary of Contents for modway Shore EEI-2264

  • Page 1 EEI-2264 CORNER Thank you for purchasing the MODWAY CORNER! Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. 2.Owing to the size and weight of the corner, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
  • Page 2 EEI-2264 CORNER STEP 1: Remove the plastic covers which pre-install in the end of the Seat Frame (4) by using Allen Wrench (C). Please put left Leg (2) on a carpeted or padded area. Insert Top Rail (1) and Seat Frame (4) into Left Leg (2) as shown. Insert 3 pieces of Bolt (B) from the pre-drilled holes on the bottom of the Top Rail (1) and Seat Frame (4) into each side on the bottom of Left Leg (2).

Table of Contents